+62-21-344 2919      +62-21-3511 428      +62-811-9119-611   
    deltacrete@gmail.com      Senin - Jumat 9.00 - 17.00

Deltagrout EP Injection

Low Viscosity Epoxy Resin Injection

DESCRIPTION

A solvent free, two-component super low viscosity liquid based on high strength epoxy resins. Especially for injection into cavities and cracks in concrete.

USES

To fill and seal cavities and crack in structural concrete such as columns, beams, foundations, decks and water-retaining structures.

ADVANTAGES

  • Super low viscosity
  • Suitable for both dry and damp conditions
  • High mechanical and adhesive strength
  • Low creep characteristic under sustained loading
  • Non-shrink and hence ensures complete surface contact and bond
  • Hard but non brittle, high compressive, tensile and flexural strength

INSTRUCTION FOR USE

Surface Preparation

Surface must be clean and sound. It may be dry or damp, but free of standing water.

Mixing

Pre-mix each component. Pour all the contents of the hardener pack into the base container, and mix using a slow speed (400-600 rpm) power mixer until homogeneous.

Application

To Gravity feed crack – Pour Deltagrout EP Injection into the open crack until completely filled.

To Pressure inject cracks – Use automatic injection equipment or manual method.

LIMITATIONS

Maximum crack width 5 mm

Minimum crack width 0,20 mm

Minimum age of concrete must be 28 days prior to application.

CAUTION

Wear protective clothing, goggles, gloves and or barrier cream. In case of contact with skin, wash plenty of water immediately and consult a physician.

STORAGE

When stored in dry conditions at 5 - 35 ºC, the shelf life is 12 months.

TECHNICAL DATA

Colour Yellowish
Mix Density 1,08 kg/l
Viscosity 180 + 25 cps
Pot Life at 30 ºC 20 minutes
Tensile Strength at 7 days 28 N/mm2
Flexural Strength at 7 days 40 N/mm2
Bond Strength to concrete at 28 days 3 N/mm2 (concrete failure)
Bond Strength to steel at 28 days 9 N/mm2
Compressive Strength at 7 days 70 N/mm2
Packaging 5 kg set can (A+B)

HEALTH AND SAFETY

Deltacon EP Injection may cause harm in some skin contact, avoid contact with skins, eyes and

inhalation of vapor. Protective gloves and eyes protection are highly recommended during work of

application.

FIRE

Deltacon EP Injection is non-flammable material.

Our Location

PT. Deltacretindo Wira Mandiri
  JL. Pintu Air IV No. 41A
  Jakarta, Indonesia 10710
  +62-21-344 2919
  +62-21-3511 428
  +62-811-9119-611
   :  deltacrete@gmail.com

haki cm

Print
© 2017 Deltacretindo. All Rights Reserved. Powered By GM-Portalindo