+62-21-344 2919      +62-21-3511 428      +62-811-9119-611   
    deltacrete@gmail.com      Senin - Jumat 9.00 - 17.00

Deltacon EP Mortar

Epoxy Based Mortar Repair

DESCRIPTION

Deltacon EP Mortar is an adhesive compound made from blended epoxy resin adhesive and special fine fillers. This two components adhesive and repair mortar are designed for structural use, ensuring a very good bonding of concrete elements, masonry, ceramic, wood, asbestos, cement, polyester.

USES

Deltacon EP Mortar can be used for structural repair; sealing cracks and joints in concrete, bonding concrete elements. Installation of reinforcement starter bars, bolts, dowels, pin.

ADVANTAGES

  • High strength bonding
  • Fast curing
  • No shrinkage free
  • Pre packed with an easy to use method

INSTRUCTION FOR USE

Surface Preparation

Concrete must be clean and sound, dry and free from oil or grease, laitance and dust. Some Preparation work may needed to concrete by using approved mechanical methods such as sandblast. Steel bar should be free from any grease and rust.

Application

Stir each component first before mixed them together. Then part B - hardener should be added to the part A component, mixed them in part A base can for minimum three minutes using slow speed driller. Please ensure after mixing, the mixture will have an uniform grey colour.

For Pre Cast Element

The mix adhesive should be applied at the required thickness, layer by layer using notched trowel or other suitable spreader tools. Please ensure that the bonded elements are supported firmly in place until adhesive compound has fully set.

For Steel Anchoring

The mixture shall be poured or pumped into the anchor hole. Anchor bar then pressed into the filled hole up to required depth. Please ensure that the anchor are undisturbed in its position until the adhesive compound has fully set.

PACKING AND SIZE

Deltacon EP Mortar is in one set ; 5 kg, 2 component.

STORAGE

Deltacon EP Mortar has a shelf life of 12 months if kept 35 ºC or below in unopened containers.

TECHNICAL DATA

Colour Concrete Grey
Mixed Density (Kg/m3) 1850
Pot Life (minutes) 60 (25 ºC)
Compressive strength (N/mm2) 60 N/mm2 @ 1 day
70 N/mm2 @ 3 days
80 N/mm2 @ 7 days
Tensile Strength (N/mm2) – BS 6319 part 7, 1990 22 N/mm2 @ 7 days
Flexural Strength (N/mm2) – BS 6319 part 3, 1990 50 N/mm2 @ 7 days
Bond Strength (N/mm2) – BS 6319 part 4, 1990 40 N/mm2 @ 7 days
Packaging 5 kg set can ( A + B )

HEALTH AND SAFETY

Deltacon EP Mortar may caused harm in some skin contact, avoid contact with skins, eyes and inhalation of vapor. Protective gloves and eyes protection are highly recommended during work of application.

Deltacon EP Mortar contains solvent that is a flammable liquid, and only be used in well ventilated areas.

FIRE

Deltacon EP Mortar is non-flammable material.

REFERENSI PROYEK

Our Location

PT. Deltacretindo Wira Mandiri
  JL. Pintu Air IV No. 41A
  Jakarta, Indonesia 10710
  +62-21-344 2919
  +62-21-3511 428
  +62-811-9119-611
   :  deltacrete@gmail.com

haki cm

Print
© 2017 Deltacretindo. All Rights Reserved. Powered By GM-Portalindo