- VH. Gadjahmada
- Products
- Hits: 1349
Solvent Based Epoxy Primer Coating
DESCRIPTION
Deltaprime TC is a two components solvent based primer of epoxy coating based on epoxy resin and hardener, used to primed concrete surface. It provides film which is tough, dustproof and resistant to a wide range of chemicals. It is commonly utilized as part of a complete flooring system in conjunction with Deltafloor products.
USES
As primer for industrial flooring like production areas, warehouse, etc.
As a bonding for epoxy floor coating that provide excellent “hide” and coverage.
ADVANTAGES
• Low viscosity formulation penetrates and seals concrete pores.
• Excellent adhesion
CONSUMPTION
Deltaprime TC consumption is 0.25 kg/m2
APPLICATION INSTRUCTION
Surface Application
New surfaces : new concrete should be cured a minimum of 28 days, substrate should have a stable, clean and chalk free surfaces.
Old surfaces : previous coatings should be removed by chipping, grinding or sandblasting and free from oil and grease.
All surface irregularities, cracks, expansion joints, and control joints should be properly addressed prior to application. Moisture content of the substrate should be less than 5%. Humadity is not more than 75% measured in accordance with BS 8203.
Application
Component A should be premixed prior to using due to possible additive separation
Mix components A and B for a minimum of 2 minutes thoroughly.
Use brush, roll or spray gun to apply Deltaprime TC
Allow first coat to dry for approximately 2 hours. Second coat must be applied at a 900 angle to the first coat.
Note :
Double priming will greatly reduce the effects of out gassing by additionally filling the pores in the concrete. Primed surfaces should be recoated within 24 hours. For longer waiting periods, wipe with xylene until surface become tacky. If surface remains hard, abrasive sanding is required.
CLEANING
Immediately after use, the application equipment should be cleaned out with solvent/thinner.
PROPERTIES
| Specific Gravity at 250 C | 0.943 – 1.154 |
| Colour | Yellow liquid |
| Dry Film Colour | Clear |
| Setting Time (approx) | 3 – 4 hours |
TECHNICAL DATA
|
Form |
Liquid (component A and B) |
|
Colour |
Component A = Clear ; Component B = Yellowish |
|
Mix Density |
0.943 – 1.154 kg/litre |
|
Shelf Life |
1 year when unopenend and stored in dry conditions |
|
Packaging |
5 kg set (component A+B) Comp. A (enamel) : 4 kg /can Comp. B (hardener) : 1 kg/can |
HEALTH AND SAFETY
Deltaprime TC should not come in contact with the skin and eyes or be swallowed. Ensure adequate ventilation and avoid inhalation of vapours. Some people are sensitive to resins, hardeners, and solvents. Wear suitable protective clothing, gloves and eyes protection. If working in confined areas, suitable respiratory protective equipment must be used. The use of barrier creams provide additional ski protection. In case of contact with skin, rinse with plenty of clean water and seek medical advice. If swallowed, seek medical attention immediately do not induce vomiting.
FIRE
Deltaprime TC is flammable, keep away from source of ignition. No smoking. In the event of fire, extinguish with CO2 or foam, do not use a water jet.